Home > Products > Other Wire Mesh > Rockfall protection netting

Tecco Mesh – Active Rockfall Barrier of slope protection

Tecco mesh is made of high carbon steel wire. Tecco mesh system is a kind of active rockfall barrier system, including tecco mesh, wire rope anchor, spike plate, boundary rope, sewing rope and steel clips. With the wire ropes and steel clips, the tecco mesh is fastened onto the mountain or slope surface tightly and firmly to block the large stones and reduce the damage of landslip or debris flow.

Inquire Now Next Product

Share

Product Details

Tecco Mesh – Active Rockfall Barrier of slope protection


Product description


Tecco mesh is made of high carbon steel wire. Tecco mesh system is a kind of active rockfall barrier system, including tecco mesh, wire rope anchor, spike plate, boundary rope, sewing rope and steel clips. With the wire ropes and steel clips, the tecco mesh is fastened onto the mountain or slope surface tightly and firmly to block the large stones and reduce the damage of landslip or debris flow.


Specification


Materia: High carbon steel wire.

Surface treatment: Hot dipped galvanized, zinc-aluminum coated.
Zinc thickness: No less than 150 g/m2.
Wire diameter: 3 mm, 4 mm.
Mesh type: Rhomboid hole.
Mesh size : 65 mm inscribed circle diameter.
Tensile strength:  Minimum 1770 MPa.
Braking load of single wire: 12.5 kN.
Mesh roll width: 1–3.5 m.
Mesh roll length:10–30 m.Fitting : Steel anchor, claw type spike plate, soil or rock nails, clips, sewing rope, boundary rope. (The steel anchor is made of deformed steel bar of 25 mm diameter)


Components


The TECCO system consists of four main components that are carefully coordinated with each other:

1). TECCO steel wire mesh
TECCO mesh is made of high-tensile steel wire with an ultimate tensile strength of  1770 N/mm2.
2). TECCO spike plates
Rigid spike plates that are reinforced with ribbing ensure optimal load transmission from soil or rock anchors to the TECCO mesh.These plates are placed over the anchor heads and tightened to pre-tension the mesh onto the slope.
3). TECCO connection clips
The connection clips high-strength steel wire connection clips enable mesh sections to be joined without overlapping and still guarantee one hundred percent transfer of forces.These claw are hot dip galvanized and consist of 0.25"(6mm) thick steel spiral.
4). Soil or rock nails
Adapted to the local soil and rock static requirements, the TECCO mesh can be anchored in accordance with our dimensioning concept with commercial soil or rock nails.The main anchors of the system are installed in a grid typically from 6.6 to 16.4 ft (2.0 to 5.0m) horizontal and vertical spacing.Actual spacing depends upon the results of site analysis and modeling.Anchor consist of commercially available steel bars ranging from 1.0 to 1.25 ft (25 to 32mm).Selfdrilling grout injection anchors are also permitted.Additional anchors may also be used to provide added support at boundaries and in low points and hollows.


Feature


High safety and tensile strength.

Rhomboid mesh structure for stability.
Corrosion and rust resistance.
Environmental friendly for plant growth.
Easy to install and transport.
Durable and long service life.


Application


The tecco grid is usually installed on soil or rocky textured surfaces such as mountains and slopes to prevent falling rocks and to ensure plant growth. In addition, it can be used to control water, soil loss and external soil spray sowing.


Contact Us
skype
WhatsApp
E-mail